We will no longer be carrying this item, thus once existing inventory is exhausted, that will be it. Therefore, your size/color combination may not be available...however, we will let you know ASAP if another color is available for substitution. Otherwise, we will notify you of the out-of-stock situation and cancel your order for you.

NOTE ON COLOR: The Wilderness is phasing out OD Green and replacing with "Wilderness OD Green" which is nearly the same as Foliage Green. We have a few belts in OD, but once those are gone, they are gone and all green belts will be the new Foliage Green.

It is a very strong belt with a specially designed "V" ring buckle coated with a technical non-glare black coating. The belt was originally designed to clip into a secure system while "instructing" others in high places.

We offer the 1-1/2” 5-stitch only, as we believe this belt is the best compromise of rigidity, width and pricing.

VERY IMPORTANT: WILDERNESS BELT SIZE MEASURING INSTRUCTIONS

Wilderness belts are sized by a true measured belt size. We ask that you put a cloth tape through the belt loops of the pants that you would normally wear the belt with, pulling as tightly as you typically pull a belt, and measure to the nearest inch. If you regularly wear an in-the-waistband holster and mag pouches, we recommend you place them in your pants for measuring.

Ideally, the hook fastener material on the belt tab should center evenly in the loop fastener material area on the belt body. From an ideal fit you will then have an 1-3/4" of adjustment in each direction. This is usually enough of an adjustment to cinch down for something heavy on the outside of the belt, or loosen the belt for an in-the-waistband holster. If your I.W.B. holster is for a particularly thick gun, you may want to assume an extra inch.

You can also measure by laying a leather belt out flat on a table, and measure from the inside edge of the buckle away from the hinge to the hole that you currently use (it is important that the inside length of the buckle be included in the measurement,) and as above, measure to the nearest single inch.

Available in even sizes from 30-42”. For sizes 44-49”, please add $5.00, sizes 50-59” please add $10.00. Belts 44" and larger, or 29" and smaller, are custom made and non-returnable.

NOTE: This, or any other rigger's type belt, should be used in conjunction with a tactical / rappelling harness to ensure maximum safety. It is not recommended to use any rigger's type belt as a stand-alone safety device.

Wilderness Tactical Products